14
Feb
Before new fuel gas piping can be connected to a combustion turbine CT it must be cleaned by decompression gas blows. Remove fuel level sender and fuel pump and baffle assembly.
Leave the fuel lines from the top of the pump connected to the car body for now note which one was connected to the top of the pump.
How to clean fuel lines. Cleaning steel fuel lines - YouTube. Replace them the tubing doesnt cost muchYou have no idea the crap and varnish you will find in thereI had my tank boiled out because the car had sat for over five years I ran a yard stick into the filler and it can out like soft tarWhile the tank was out I capped off the line up at the fuel pump fitting and sprayed Berryman Chemtool in the line till it was full and let it sit 3. CLEANING OF OIL GAS PIPELINES ON-LINE OFF-LINE By Theo Verleun N-SPEC an activity of Brenntag Summary.
The outcome of the last Pipeline and Pigging Conference in Houston February 2003 could be summarized. Place a hand full of nuts and bolts into the gas tank to clean varnish out. Roll the fasteners around in the tank for five to 10 minutes.
Dump the fasteners out and spray the gas tank out again. How To Clean A Fuel Tank Without Removing It. First you need to disconnect the fuel lines.
Drain the fuel tank completely. Then use a pressure washer to wash out the debris and rust. Apply a cleaning solution and leave it for a couple hours.
Rinse the tank with water and leave it to dry for 48 hours. Cleaning the tank. Remove access covers in front trunk.
Remove fuel level sender and fuel pump and baffle assembly. Save the oem baffle even if you decide to go aftermarket. Leave the fuel lines from the top of the pump connected to the car body for now note which one was connected to the top of the pump.
Before new fuel gas piping can be connected to a combustion turbine CT it must be cleaned by decompression gas blows. Heres how to do it. Remove the hose clamp on the fuel line using the flat-head screwdriver.
Pull the fuel line back off of the fuel pump to separate it. Look for a pinch point on the clip as most of these fuel pump connections are quick-connect styles. Disconnect the fuel line from the carburetor.
Let the fuel run through the line into a clean container until the tank is empty. Run a clean piece of wire through the fuel line until it reaches the tank. Pour about 2 cups of fuel into the tank and let it run through the fuel line into a different container.
Drain any excess fuel from the line and filter into the gasoline container. Run the end of the coat hanger through the rubber fuel line to clean out any debris lodged inside the hose. Nothing you can buy to fix it.
Best way is to unhook both ends and use compressed air to blow it out from front to back. Dont know how your lines could get clogged up. The pump has a filter sock where it takes in the gas.
If that is plugged or broken and you had trash or debris in the tank then it could be a clogged line.